Rusty's not very quiet cuda progress

[RUSTY Cuda]

tape off before sanding!

 

[RUSTY Cuda]

Sand the bottom workin bottom up towards the line, tape just below the line & putty the top, this is where she was left, putty dryin, so the verdict isn't in yet, bottom half looked ok? Rich.

 

[RUSTY Cuda]

a little oasis in the winter here, tomorrow supposed to be nice too, maybe i can shoot some prime, so when it gets cold again I can at least wet sand some parts!
Nice to be at it again! [smilie=e: Rich.

 

[beeper*71]

[smilie=e: [smilie=e: [smilie=e: [smilie=e: [smilie=e: [smilie=a:

 

[RUSTY Cuda]

Got some hours in & I almost have that body line, bad angle were it was hangin after prime , looks like it needs a bit more work , 3 times is the charm right!

 

[RUSTY Cuda]

But this I got ! My engine hoist, a loan of the pickup & charger mans lazyness was the price for it(he was tired of takin it apart & bought a fold up) [smilie=e: Rich

 

[RUSTY Cuda]

Body shop in full tilt, sanded a bunch a parts......

 

[beeper*71]

[smilie=e: [smilie=e:

 

[RUSTY Cuda]

for the next primer coat.......

 

[RUSTY Cuda]

& shot away!, had to do the hood again cause I messed up yesterday, tried to smooth some drips with a brush, an idea that would have been better left untried!(didn't sand out very well)so I will sand it yet again next chance I get, NICE to be gettin some stuff done again,hope to hit that passenger apron soon then it's up on the rotis to do the bottom! [smilie=e: Rich.

 

[RUSTY Cuda]

Got the inner apron coated today, as soon as the weather comes back I'll hack it up & install the back half!

 

[RUSTY Cuda]

k, here's the results on that front valence, figgering where it's gonna be, it's goin back on

 

[RUSTY Cuda]

& hopefully the last coat a prime on the header panel, 600 wet & ready for paint! [smilie=e: Rich.

 

[RUSTY Cuda]

Started on the underside of hood, a pitted mess, after sandin the prime through in a lot a spots I decided to hit it with another coat a por15, the primer sticks to it so I hope it sticks to the primer! [smilie=e:

 

[XLR8R]

[smilie=e: [smilie=e: [smilie=e:

 

[Jester]

[smilie=e: [smilie=e: [smilie=e: [smilie=a: [smilie=e:

 

[viking]

[smilie=e: [smilie=e: [smilie=e: [smilie=e: [smilie=e: [smilie=e: [smilie=a:

 

[RUSTY Cuda]

Put on the apron, cooked dinner,washed the dishes, oh geeze wrong board, helpful hubbys is tues nite, since we're talkin aprons anyway I got the rusty piece cut loose!

 

[RUSTY Cuda]

cleaned up the exposed rust & redied it for a coat a por15 & weldin! [smilie=e:

 

[RUSTY Cuda]

Had to force my hand a bit to cut up that nice new apron, but after a tall rum I hacked into it, got it fitted & marked for spot weld holes [smilie=e:
Got the holes drilled & a coat a por 15 on the old stuff, maybe sat the weldin begins! [smilie=e: