68R/T's latest activity
-
68R/T replied to the thread Certain Auto Parts Could Be Exempted from U.S. Tariffs.It will be nice to have parts made in the USA instead of the garbage coming from China. -
68R/T replied to the thread Rusty's not very quiet cuda progress.You worry too much about details stated for a newly built engine over 50 yrs ago. "The book says"-----when the engine was new, zero...
-
68R/T replied to the thread Rusty's not very quiet cuda progress.There's always Andy Granatellis old trick, a can of good old STP. Many times back in the 60's & 70's that was the quick & simple cure...
-
68R/T replied to the thread Rusty's not very quiet cuda progress.Any reading between 20 - 60 throughout RPM range at full temp is very acceptable. You worry too much about details. 😊 One belief is...
-
68R/T replied to the thread Rusty's not very quiet cuda progress.You'll appreciate knowing the true pressure after it's installed. I have pressure gauges in all of my cars. There's a reason they call...
-
68R/T replied to the thread Rusty's not very quiet cuda progress.That plug looks perfect. (y)
-
Today she again fired right up, stayed running a while & then did that die out thing, so I restarted & sat in it with a little gas till...
-
68R/T replied to the thread Rusty's not very quiet cuda progress.Don't be too concerned with the markings for the choke. They are mostly as a suggestion. Try to keep it somewhat on the lean side, but...
-
68R/T replied to the thread Donald Trump Doesn't Care If Vehicle Prices Rise as a Result of Auto Tariffs.Neither do I.
-
68R/T replied to the thread Rusty's not very quiet cuda progress.Whether or not 1/2 lb will cause chaos is kinda moot. Can you attest to 100% accuracy of the gauge? In my opinion anything between 4-5...
-
68R/T replied to the thread Rusty's not very quiet cuda progress.With the "vapor separator" (filter) all that's needed is to plumb the return line anywhere prior to the fuel pump. Because you car did...
-
68R/T replied to the thread Rusty's not very quiet cuda progress.With an Eddy carb your idle fuel pressure should be no more than 6 psi at idle. The 2nd pic of the plug is a major improvemnt over the...
-
68R/T replied to the thread Rusty's not very quiet cuda progress.For the fuel pressure check, your filter. Low pressure can also cause your idle issues. The idle circuit needs its' ideal fuel level...
-
68R/T replied to the thread Rusty's not very quiet cuda progress.Once the word is out that you can do something, they will find you. ;)
-
68R/T replied to the thread Rusty's not very quiet cuda progress.It's a lot easier to do a restore today than it was 30+ yrs ago without interweb and very little reproduction parts. But, it's a lot...
